Fence Line & Right-of-Way Clearing in Van, TX

Overgrown fence rows, property lines, easements and ranch roads cut back to a clean strip you can fence, survey and drive.

Fence Lines in Van

Fence lines disappear fast in Smith County. Yaupon and briar grow up through the wire, sweetgum saplings push the posts over, and within a few years you cannot walk the line, let alone fix it. Property lines go the same way, and so do pipeline easements, power line rights-of-way and the ranch roads that get you to the back of the place. I clear those strips back to a clean, consistent width the whole length of the line. For a fence that means mulching the brush off the old wire so you can pull it and set new posts, with a buffer on each side so it does not close back in by next summer. For a property line it means opening a clear sight line so a surveyor can find the pins and you can see where your land stops. For easements and lanes it means a strip wide enough to drive and maintain. Linear clearing is its own kind of work: you need a clean edge, a steady width and a machine that can work tight along wire without tearing up the pasture on either side. That is what the mulcher does best, and I do a lot of it on ranchettes and acreage from Lindale to Jacksonville and Canton to Gilmer.

Fence Line & Right-of-Way Clearing in Van, TX

Land clearing in Van

Van is a small Van Zandt County town on I-20 between Lindale and Canton, best known for the Van oil field that was discovered under it in 1929 and still has pumpjacks nodding in the pastures around town. Hwy 110 runs north from the interstate through Van, FM 314 runs south toward Edom, and the land on all sides is a mix of sandy pasture, post oak and pine woods, and old lease ground that nobody has cleared since the oil boom. It is cheaper than Lindale and Tyler and an easy run to Dallas on I-20, so acreage around Van is moving. I clear homesites and drives for people building out here, mulch understory on wooded tracts off Hwy 110 and FM 314, clear fence lines and reopen lease roads and pipeline rights-of-way on old oil field acreage, and take back pasture that has gone to sweetgum, briars and cedar. The ground is sandy and the brush comes back fast, so I lean on mulching: it clears everything in a pass, leaves chips on the ground instead of bare sand, and costs less per acre than a push-and-burn clear. Per-acre or per-job price, set after I walk the tract with you.

  • Fence rows mulched clean so posts can be set and wire stretched
  • Property lines opened for sight, survey and marking
  • Pipeline, utility and access easements cleared to width
  • Ranch roads, lanes and lease roads reopened
  • Clean edge and steady width the full length of the line
  • Mowable buffer left so the line stays open

Need fence lines elsewhere? See all of my Van services or fence lines across Tyler.

Fence Lines in Van

Tell me about the property and I’ll call you back. Local Van land clearing.

Prefer to talk now? Call or text (903) 964-3403.

Areas We Cover in Van

In town or out on a county road: if it’s in or around Van, I come to your property.

  • I-20 corridor
  • Hwy 110 North
  • FM 314 toward Edom
  • Edom
  • Old Van oil field
  • Ben Wheeler side

Common Clearing Scenarios in Van

The land clearing jobs I see most around here, and how I handle them.

Old oil field acreage with lease roads and pipelines

A lot of land around Van carries old well pads, lease roads and pipeline strips that have grown shut since the field slowed down. I reopen the roads, clear the rights-of-way to width and mulch the brush off old pad sites so the acreage is usable again.

Pasture going to cedar, briar and sweetgum

Van Zandt County is where East Texas pine starts giving way to post oak savannah, and the brush that takes pasture here is greenbriar, eastern red cedar and sweetgum saplings. Mulching clears all three and leaves the ground covered, not scraped.

New homesites off the interstate

People commuting toward Dallas are buying tracts off Hwy 110 and FM 314 and building. I open the pad and drive, mulch the understory on the rest and leave the oaks and pines standing.

Fence Lines in Van: FAQs

Do you clear land around Van and Edom?
Yes. Van is about 25 miles northwest of Tyler on I-20, and the country from Van down to Edom and over toward Ben Wheeler is part of my regular area.
Can you work around old wellheads and pipelines?
Yes, carefully. On old lease ground I walk the tract first to find the wellheads, markers and pipeline crossings, flag them, and keep the mulcher clear of them. If you have the operator’s plat or know where the lines run, bring it to the walk.
Is mulching the right way to clear cedar off pasture?
Yes. Cedar grinds easily and does not resprout from the stump the way yaupon and sweetgum do, so once it is mulched it is gone. Shred the pasture once or twice a year afterward and the seedlings never get started again.
Can you clear a fence line without wrecking the existing fence?
Yes. I work tight and controlled along standing wire, grinding the brush and briars off the fence without pulling the posts. If the fence is already destroyed by growth through it, I will tell you what is worth saving and what is easier to replace once the line is open.
How wide a strip do you clear?
It depends on what the line is for. A fence wants a strip wide enough to set posts and stretch wire with a mower width on each side. Pipeline and utility easements often have a required width. Tell me what the strip is for and I clear a clean, consistent line to match.
Can you open up a property line so I can get it surveyed?
That is a common job. I clear a sight line along the boundary so the surveyor can find the pins and shoot the line, and so you can see your corners from the road. If you know roughly where the pins are, flag them and I will clear to them.

Need Fence Lines in Van?

Call for a straight quote. I come to your property, walk the land with you and price it by the acre or the job.

📞 Call or text (903) 964-3403